View Full Version : Kent Tooling stand
Mr Flibble
08-07-2016, 07:47 AM
Just spotted this. Looks like the usual top quality, nicely designed kit from John. http://www.divingproducts.co.uk/oc/index.php?route=product/product&product_id=359
cathal
08-07-2016, 07:58 AM
Using one at the moment. I highly recommend it if your tall.
colinicky
08-07-2016, 11:57 AM
Yes it is good. Been diving the prototype since February :) There is also an option for D rings to bolt on the sides in effect under the cylinder valves that makes a nice addition for clipping cylinders or reels etc.
Check this link to The rEvo Facebook page & scroll down to find various comments from people using it :-
https://www.facebook.com/groups/855364507834600/?ref=bookmarks
Mikael
08-07-2016, 12:56 PM
Using one at the moment. I highly recommend it if your tall.
Where is the cut off for "tall"
:devil:
colinicky
08-07-2016, 01:04 PM
I am 5ft 8 but am short in the leg & long in the body so tall has no relevance. Plus there are various height standard legs & you can talk to John about custom length if you need .
Edit : That's custom length legs for the unit not me !!!
iamyourgasman
09-07-2016, 08:09 PM
It's a must for a mini IMHO. The D-rings are fab too.
Powered by vBulletin® Version 4.2.2 Copyright © 2023 vBulletin Solutions, Inc. All rights reserved.