BOV causing mask to leak

[Piemaster]

I started diving a Kiss Classic with a Golem Gear Shrimp late last year and have a bit of an annoying problem. The top of the BOV touches the bottom of the nose pocket on my mask so occasionally it knocks it enough to cause a small leak in the mask. I know the mask is a good fit as it's fine OC.
Has anyone else experienced the same issue or got any words of wisdom?
Pete

Sent from my Nexus 6P using Tapatalk

[Woz]

Tsk these commercial bovs are rubbish ;)

[notdeadyet]

Smaller mask?

I use an Omer freediving mask with my Golem and it's fine.

Sent from my GT-I9300 using Tapatalk

[Piemaster]

I did think about a smaller mask but I'm already using a Hollis M1 which is pretty small.

Sent from my Nexus 6P using Tapatalk

[MikeF]

sound like either your mouth is too close to your nose or you need to rotate the hoses at the T pieces so the BOV sits at a lower angle.

[PeterL]

I did think about a smaller mask but I'm already using a Hollis M1 which is pretty small.

Sent from my Nexus 6P using Tapatalk

Had the same issue with the M1, I binned it. The Beaver Atomic is a better less conflicted mask for CCR.
I would also look at your loop weighting, you need to keep the BOV down and the shrimp is very very floaty.

[Piemaster]

sound like either your mouth is too close to your nose or you need to rotate the hoses at the T pieces so the BOV sits at a lower angle.
Plastic surgery then? No T pieces but I have been twisting the BOV to try and keep it resting on my chin.

Sent from my Nexus 6P using Tapatalk

[Piemaster]

Had the same issue with the M1, I binned it. The Beaver Atomic is a better less conflicted mask for CCR.
I would also look at your loop weighting, you need to keep the BOV down and the shrimp is very very floaty.
Thanks, I'll have a look and try moving the ring weights further towards the BOV.

Sent from my Nexus 6P using Tapatalk

[ARJAYM]

I had same trouble recently after servicing bov. Realised I had refitted at wrong angle. Reset it angled down a few degrees.

[MikeF]

Plastic surgery then? No T pieces but I have been twisting the BOV to try and keep it resting on my chin.

Sent from my Nexus 6P using Tapatalk

don't just twist the hoses. slacken and rotate the hoses relative to the BOV to re-set the angle the BOV sits when it's dangling free so that it naturally points down a little when in your mouth. it can take a bit of playing with to get the BOV naturally sitting at the right angle in your mouth.